— 2 —
INCLUDED PARTS:
ONE-PIECE TOILET
INSTALLATION INSTRUCTIONS
3. Install Closet Bolts
·
Install closet bolts to flange channel, turn 90° and
slide into place 6” (152mm) apart and parallel to wall.
2. Rough-In the Toilet
·
Measure the wall from behind the toilet to the
middle of the closet bolt. Your rough-in
measurement should be 12”.
4. Install Wax Seal
·
Invert toilet on floor (use cushion to prevent
damage), and install wax ring evenly around waste
flange with tapered end of ring facing toilet. Apply
a thin bead of sealant around toilet base.
1. Turn Off Water Supply
·
Close toilet supply valve and flush tank
completely, use towel to remove excess water.
·
Disconnect and remove supply line, if you are
replacing the valve shut main water supply first.
·
Remove closet bolts from flange and clean wax
and putty from base area.
5. Position Toilet on Flange
·
Hand-tighten water supply hose to the fill valve in
the back of the toilet. Do not connect to water
supply yet.
·
Unplug floor waste opening and install toilet on
closet flange so bolts project through the
mounting holes.
·
Loosely install retainer washers and nuts.
6. Install Toilet
·
Position toilet square to wall and, with a rocking
motion, press bowl down fully on wax ring and flange.
Alternately tighten nuts until toilet is firmly sealed to
floor. Do not over-tighten nuts, it might crack ceramic.
·
Smooth off the bead of sealant around the base.
Remove excess sealant.
·
Place cover caps to hide installation holes on toilet.
·
Connect water supply to shut off valve, and check for
leaks. Tighten if necessary.
Closet Flange
Closet Bolts
Rough-in
Nut
Washer
Bolt
Wax Ring
Sealant
