25
Parking Brakes
9
The Swisher ZT2460 is equipped with an Automatic Parking
Brake system on each control handle.
9
When the control handles are in the out most position the
parking brakes are on.
9
Adjustment for the system is located on the ends of the brake
cable at the hydro pan & frame
9
Raise the rear wheel off the ground.
9
Disengage the hydro to be adjusted with the hydro release
handle at the rear of the unit
9
Adjust so that the brake is not on when the handles are in the
operator position. The wheel should turn freely.
9
The wheel should not turn when the handle is move to the
engaged or outward position.
9
To tighten the brake, turn the adjustment nuts towards the end
of the cable.
9
Recheck adjustment with control handle
9
Lower unit back to the ground
9
Reengage the hydro at the rear of the unit
SERVICE & ADJUSTMENTS
WARNING
When it is necessary to raise the mower for
any repair or service, use jackstands to
provide adequate support. DO NOT rely on
hydraulic or mechanical jacks