10. Place one side panel in position against a side
13. Assemble one M6X25 screw through bottom hole
angle and down on top of the front panel. Start one
in side panel and front angle assembly. Secure
M6X25 screw through the center hole in side
with a flat washer and hex nut,
Only
panel and side angle. Secure with hex nut and flat
finger tighten at this time.
Repeat for the other side
washer. See figure 7.
Only finger tighten at
panel. See figure 8.
this time.
14. Securely Tighten all loose nuts and screws at
11. Start one M6X25 screw through front hole on side
this time.
panel and side angle. Start another M6X25 screw
through top hole on side panel and front angle
assembly. Next, place a support strap over these
two screws and secure it with flat washers and hex
nuts.
Only finger tighten at this time.
See
figure 7.
12. Repeat steps 10 and 11 for the other side panel.
FIGURE 8
FIGURE 7
3
SIDE
PANEL
FRONT
ANGLE
ASS'Y
FRONT
PANEL
SUPPORT
STRAP
M6X25
SCREW
M6X25
SCREW
M6
HEX
NUT
M6
HEX
NUT
M6X25
SCREW
Ф
6
FLAT
WASHER
Ф
6
FLAT
WASHER
FRONT
ANGLE
ASS'Y
M6X25
SCREW
FRONT
PANEL
SIDE
PANEL
M6
HEX
NUT
Ф
6
FLAT
WASHER