RULES FOR SAFE OPERATION
ASSEMBLY INSTRUCTIONS
Preventing accidents is the responsibility of every
TOOLS REQUIRED
equipment operator. The following general safety
(1) Screw Driver
precautions must be fully understood and followed
(2) Pliers
by every operator.
(3) 10mm Wrench
1. Do not at any time carry passengers in this cart.
This cart is designed for carrying materials only, and When assembling your cart, place the heads of all
NEVER to carry passengers.
screws to the inside and hex nuts with flat washers
2. Be cautious of any steep grade or hills; stay clear of to the outside.
steep grades.
3. Use caution when loading cart to avoid tipping.
1. Lay the front angle assembly down (flat) on floor
4. Avoid large holes and ditches when transporting
and stand the bottom panel in position as shown in
loads.
figure 2.
5. CAPACITY OF THIS CART IS 300LBS.
DO NOT OVERLOAD CART!
Your Garden Cart carton contains a hardware
NOTE
package with parts as shown in the chart below
The bottom panel has one galvanized
and in figure 1.
edge; this is the rear. The front edge
has three holes. See figure 2.
Contents of Hardware Pack: (See figure 1)
REF.
QTY.
DESCRIPTION
2. Line up three holes in bottom panel with holes in
A
8
Screws,M6X50
front angle assembly. Start three M6X25 screws
B
4
Screws,M6X30
through bottom panel, then through angle. Secure
C
15
Screws,M6X25
screws with Ф6 flat washers and M6 hex nuts.
D
4
Cotter Pins
Tighten securely.
See figure 2.
E
27
Hex Nuts,M6
F
23
Flat Washer,Ф6
G
4
Lock Washer,Ф6
H
4
Large Flat Washer
HARDWARE REFERENCE CHART
FIGURE 2
FIGURE 1
1
H
G
F
E
M6X50
M6X30
D
C
B
A
M6X25
FRONT
ANGLE
ASSEMBLY
THREE
HOLES
FRONT
EDGE
M6
SCREW
Ф
6
FLAT
WASHER
BOTTOM
PANEL
M6
HEX
NUT