Hold down the Enter/Configure button to configure your first interval. Use the Brightness
button to choose your appropriate interval. Hold the Enter/Configure button down again to
save your first interval and move on to your second interval. Hold the Enter/Configure button
down again to configure your third interval. You will be prompted to enter a fourth interval.
Let’s say you don’t want to enter any more intervals. That is fine, this fourth interval was not
saved yet, only the first three. Click Start/Stop/Pause. The clock is now programmed and ready
to start.
Double click the Enter/Configure button to toggle between Counting Up & Counting Down.
Click Start/Stop/Pause button to begin your set.
When your set is finished, your clock will elicit a long beep and begin to default count up again.
Mode 6: Stopwatch
Click Start/Stop/Pause button to start the stopwatch. Click it again to stop. Double click it to
reset.
Bluetooth
Download the Swimnerd mobile app on iOS or Google. Once signed up, go to TOOLS –
CONNECT TO CLOCK – SCAN.
HC-08 will show up. Click on it to connect. Now, you can change the name by clicking the i icon.
Click CLOCK on the bottom of the app. This clock control center is basically a super remote.
Program anything you want into it with just a few clicks. Including, any sort of descending or
ascending ladder set.
Charging
Each Swimnerd PPC comes with a USB-C to USB-A charging cable. Connect it into your phone
block, and you are ready to charge.
There is a little red indicator light on the top of the clock. When it turns off, your clock is fully
charged.
When you plug in your PPC, it will automatically turn on. If you turn it OFF while it is charging,
just realize that it is not actually OFF, as it can still be found by Bluetooth. So, if you take it off
the charger while it is off, it is not actually off. Turn it on then off. If your clock says OFF, it’s off.
