Swift Group 2013 Holiday Home, Руководство пользователя

Страница: 42 / 108

38
General Care
If a water supply is fed by gravity then the
supply pressure should be verified to ensure
the conditions of use are appropriate for the
valve.
ATTENTION: in order to assure the maximum
efficiency of the mixer, the operating pressures
(on hot and cold line) should be kept as
balanced as possible and the inlet hot water
must be at least 10°C above the required
blend temperature.
When pressure is higher than 5 bar a pressure
reducer is required to be fitted before the
mixer.
DRAIN DOWN PROCEDURE
1. Close hot and cold mains feed taps.
2. To drain Thermostatic mixer:
• Remove the shower hose from the mixer
or lay the showerhead and hose in the
shower tray to drain off any trapped water.
• Turn bottom tap valve fully open
• Turn the top thermostat valve fully
clockwise to drain cold water, until water
stops flowing.
Push in the red temperature set button on the
top thermostat valve and turn fully
anticlockwise to drain the hot water side until
the water stops flowing.
Note: If after the drain down procedure the
Thermostatic Mixer Tap is to be left for long
periods in cold or freezing conditions, leave the
tap open and line up the ridge on the
thermostat hand wheel with the letter “H”
etched on the tap body.
PROTECTING YOUR THERMOSTATIC
MIXING TAP
In addition to draining down the Thermostatic
Mixer Tap in periods of cold and freezing
conditions, to offer maximum protection it is
highly recommended that the Thermostatic
Mixer Tap is further protected by following the
method outlined below:
First complete the drain down procedure
ensuring the hot and cold feeds are isolated
and fully drained.
Using an allen key, remove the mixer body
from the tails by releasing the grub screws
taking care not to misplace these.
The unit can then be completely drained, dried
and wrapped in a soft cloth for storage away
from frost until required.
The Thermostatic Mixer Tap can then be
re-attached as follows;
Re-fit body to the tails and tighten the
grub screws, take care not to over tighten.
Re-connect to the water supplies and
check seals.
PROTECTING YOUR THERMOSTATIC
MIXER VALVE (BATH)
In addition to a shower Thermostatic Mixer
Tap, if the Holiday Home has a bath fitted there
will be a Thermostatic Mixer Valve to regulate
the water temperature to the bath, this will be
accessed by removing (lifting) the lid covering
the toilet system. This should be removed or
correctly drained down during months in which
frost may occur.
FOR INFORMATION THAT IS MORE
COMPREHENSIVE REFER TO YOUR V100
TMV2 USER AND MAINTENANCE
INSTRUCTION BOOKLET.
CLEANING
Your fitting has a high quality finish and should
be treated with care to preserve the visible
surfaces.
All surface finishes will wear if not cleaned
correctly. The only safe way to clean your
mixer is using soap water and a cloth. To dry
use a soft cloth. Stains can be removed using