6. Logging
Logging can be initiated in two different ways. The first method is to
select
Mode
and thereafter
LOG
and
Enter
. This leads to the bat-
tery setting (battery symbol). This can also be accessed by selecting
Mode
followed by
Settings
and then by navigating to this setting.
To initiate a logging see
Battery symbol - initiate logging
in
5. Set-
tings (SEtt InGS)
.
NOTE!
If the battery runs out during the logging, the instrument will shut
off after the logging has been saved. If the pump is turned on during
the start of the logging, the pump will work for 30 seconds before the
measurement is taken. At other times the pump is shut off, meaning the
pump is always on if the interval is set to 30 seconds or less.
To stop and save a log, press
All
.
For a brief moment the display will read Notebook with ”n3” blinking,
which in this case means that the log was saved as measurement series
3 in notebook. The instrument then switches back to measuring mode
without logging.
7. PC transfer
Install the following program
Swema Terminal 3
which can be found
on Swema’s website. After the installation is complete, connect the
instrument with its included
USB-ADAPTER
, make sure this is done
before starting the program. The
USB port LED
should be lit green.
Start the program
.
Click on
Ter..
”Terminal COM22” and then press
”Enter” to access the menu.
SwemaCO2 410 S/N: 671099
Firmware: 1.30 Hardware: 1.00
[O] Decimal delimiter: Point
[U] Unit system: SI
[S] Auto shutoff after: 60.0 passive minutes
[P] Print calibration certificate
[L] Print note (all measurements)
[N] Print notes
[ ] Space - Print measurement values
[,] Comma - Print measurement values with units
5.
