©2021 Swellpro Technology Co., Limited 33
Setting No Fly Zones
No fly zone can be set by choosing a
central point and radius in the app. After
setting, the drone will not take-off or fly in
this area.
Night Lights
The top of the fuselage is equipped with high-intensity strobe light, which helps identify the
drone
’s position to the pilot and other air traffic. This
meets the requirements of night flight
regulations in some countries and helps ensure flight safety at night. The strobe can be
activated and deactivated in the app (STB).
Installing the Camera
1.
Unsrew and remove the waterproof cover plate for the Gimbal
Camera, located on the underside of the drone body.
2.
Carefully insert the
camera’s connector
plug into the
drone’s
interface then secure with a screwdriver. Screws should be firmly
tightened but care must be taken to not exert too much force.
3.
Align the gimbal with the mounting points on the bottom of the
drone and screw the camera onto the drone to complete the
installation.
Note: ENSURE that the orange o-ring is correctly positioned on the camera plug and that it is
clean and lightly lubricated with silicone lubricant before installation. Sealing surfaces must be
clean and free of all dust or other contaminants.
