4 ©2021 SwellPro
Precaution
⚫
The FAC camera is a piece of precision electronics with corrosion-resistant
materials which allow for use in harsh marine environments. As with any marine
equipment, trouble-free and lasting operations depend on proper attention and
maintenance of the equipment.
⚫
When taking off or landing, slowly proceed to avoid damage to the camera which
can cause by the huge impact when contacting the surface at high speeds. Drop or
crash directly into the water from above will result in significant damage to the
drone and the camera.
⚫
After using in seawater, soak and rinse thoroughly with clean fresh water before the
seawater dries out.
⚫
If seawater or other sediments form on the camera, soak thoroughly with fresh
water and clean all sediments on the camera before use. For more information,
check the
drone’s
“
Maintenance manual
”
.
Installation
Install the Camera
1. Unscrew and take off the camera port cover plate
using a hex screwdriver. (equipped with SplashDrone
4)
2. Plug the camera
connector into the drone’s gimbal
port and screw it in place with a screwdriver.
Make sure the rubber ring is attached to the camera
connector before you screw the connector.
Make sure the connector plate is clean and free of
any sand or other particles.
