Swegon TACtouch, Руководство по эксплуатации и сборке

Страница: 6 / 15

6
Manufacturer bears no responsibility for
damages caused by non-observance of this
manual.
9.4 Control panel installation
Possible methods of installation of the control
panel on or in a wall. Drill a hole in the mounting
plate acc. the below drawing or do it mounting
the panel onto mounting screws with spacing
indicated.
Control panel mounting requirements. 1 –
control panel, 2 – vent holes to provide air circulation.
• Disassembly of control panel
During panel de-installation (see fig. below), to
remove the panel (1) from the casing, insert the
flat elements (2) into gaps indicated in the
figure. It will cause the casing clamps to open
and allow you to remove the panel (1).
A proper air circulation should be provided
through ventilation openings and proper
panel housing, not to exceed a maximum
temperature of 40°C ambient panel.
The holes may not cause downgrading of
required IP rating. They are not required if
permitted ambient temperature around the
control panel is not exceeded
.