I NSTA LLATIO N
– OPERATING - MAINTENANCE
2
SILVER M
INSTALLATION
– OPERATING - MAINTENANCE
1.
General
1.1.
Intended utilisation
The equipment delivered by Huber & Ranner GmbH may be used
only for the conditioning of air. This applies to air filters, heaters,
coolers, humidifiers, dehumidifiers and conveyors. Any other usage
is specifically prohibited by Huber & Ranner GmbH.
The continuous observance of the existing installation, operating,
service and maintenance instructions is also considered integral to
intended utilisation!
Technical data
Technical specifications can be determined from the equipment
cards.
For technical related questions, please contact our customer service
department.
Telephone: 0049(0)8531/705-45
Fax: 0049(0)8531/705-21
Email: [email protected]
1.2.
Hazards
The equipment should not be opened or accessed during
operation!
All rotating parts should be allowed to first come to a standstill.
Mechanical hazards
-
Crushing injury to the hands on the suction-side doors
-
Blowing open of doors with a pressure-side configuration
-
Faulty damper switching (over or under pressure) can lead to
destruction of equipment components.
-
The crushing of fingers when the air regulator and shut-off
dampers are moved.
-
Never put hands in the vicinity of rotating parts, such as
ventilators, drive belts, WRG-rotors, etc.
-
Loose or non-clinging pieces of clothing in the vicinity of the
suction openings and drive belts can lead to life threatening
injuries!
Hazards due to electrical energy
-
Danger of short circuiting when connecting electrical
components.
-
Due to high voltage and strong amperage, work should be
carried out only in a potential-free state.
-
Due to static charge on the housing, proper grounding should
observed.
-
All cables should be inspected for installation damage prior to
commissioning
-
Explosion hazard when conveying an explosive atmosphere
(see Chapter 8: Ex-protection)
Hazard due to vibrations
Every operation has a critical turning speed range.
When operating in its range of resonance, the ventilator unit can
experience mechanical damage.
The range of resonance for turning speed regulated drives is to be
determined during commissioning, bridged over and recorded.
Hazard due to operating media/materials
-
Refrigerant from direct evaporator or condenser may not
-
be allowed to leak into the environment.
In the event of fire, poisonous gases and smoke (flammable
materials) can result, which must not be inhaled.
-
Avoid bodily contact with brine when cleaning, filling or
emptying. Danger of poisoning and injury! Observe
manufacturer's information.
-
Compressor oil can provoke allergic reactions if contacted or
swallowed. Avoid bodily contact
-
When cleaning the equipment, care must be taken, that dust
from the filters or components is not inhaled, as allergens,
fungi and bacteria may be contained therein.
Hazard due to thermal influences
-
Burn hazard from pipelines.
-
Dangerous operating media include the electrical heater,
vapour humidifier and hot water.
-
Freeze-burn hazard from cold parts (e.g. cold water lines,
refrigerant lines) and cold components (e.g. cooler, suction
chamber)