Swegon
Connect
We reserve the right to alter specifications.
20170622
2
Mount and use
DIV
GPS
ANT
PWR
USB
ETH0
ETH1
IN0 IN1 OUT
IN0
IN1
OUT
SIM
WAN
DAT
PWR
USR
POE
SmartFlex
Figure 3: Connecting power
First use
Before you put router into operation, it is necessary to connect
components that are needed to run your application.
Antenna
Connect the external antenna to the ANT connection on
the router. Please use the accessory TBRX-1-12, either 1 or
10 meters, if you need to extend the antenna cable.
The router cannot operate without antenna attached, SIM
card inserted (pre-mounted) and power supply connected.
The router must be connected to antenna while in operation,
otherwise damage to the router may occur.
Use SMA connector for antenna connection. Antenna is
primarily connected by screwing at ANT, see figure 1. An
additional antenna can be connected at DIV for better
signal strength.
Network (Ethernet)
The router have by default a standard network port (ETH1)
for connecting products, see figure 2. If additional connec-
tions are required use the accessory Switch.
Use the router’s other network port (ETH0) when you
want to connect to a building network or a BMS system.
* Please contact Swegon for adapting the router to
a BMS connection.
Power
The supplied transformer must always be used for
connecting to the power grid. First connect the power
cable to the router and tighten the connector screws.
Then connect the transformer’s power plug to an
electrical outlet.
DIV
GPS
ANT
PWR
USB
ETH0
ETH1
IN0 IN1 OUT
IN0
IN1
OUT
SIM
WAN
DAT
PWR
USR
POE
SmartFlex
Figure 2: Connecting network
A: Products/switch or LAN/BMS* to ETH0
B: Products/switch to ETH1
A
B
DIV
GPS
ANT
PWR
USB
ETH0
ETH1
IN0 IN1 OUT
IN0
IN1
OUT
SIM
WAN
DAT
PWR
USR
POE
SmartFlex
Figure 1: Connecting antenna(s)
DIV
ANT
B
A
A: Primary antenna to ANT
B: Additional antenna to DIV (option)
GPS