Sweepster VRS Series, Руководство пользователя, Страница: 8 / 54

8
SeRViCe & RePaiR - SafeTy
CaUTiON - DO NOT MODify THe SWeePeR
iN aNy Way. Personal injury could
result. If you have questions, contact
your dealer or SweePSteR.
Repair or adjust the sweeper in a safe area, away
from traffic and other hazards.
before adjusting or servicing the sweeper, lower
the sweeper to the ground, stop the prime mover
engine, set the brakes and remove the key from the
ignition.
when working on or around the sweeper, lower it
to the ground or secure it with transport chains or
cylinder-stop locks.
Stop the prime mover engine and cycle control
levers to release hydraulic pressure before servicing
or adjusting sweeper hydraulic systems.
WaRNiNG - eSCaPiNG HyDRaUliC flUiD can
have enough pressure to penetrate
the skin, causing serious personal
injury.
Do not bend high pressure lines. Do not strike high
pressure lines. Do not install bent lines, bent tubes,
or kinked hoses. Do not install damaged lines,
tubes, or hoses.
Repair damaged or loose lines, tubes and hoses.
Leaks can cause fires. See your SWEEPSTER
dealer for repair or replacement parts.
Replace the parts if any of the following conditions
are present:
• The end fittings are damaged or leaking.
• the outer covering is chafed or cut.
• the reinforcing wire layer is exposed.
• the outer covering is ballooning locally.
• the hose is kinked or crushed.
• the hose has been pulled or stretched.
Make sure that all clamps, guards, and shields are
installed correctly.
OPeRaTiON
CaUTiON - a SWeePeR iS a DeMaNDiNG
MaCHiNe. only fully trained
operators or trainee operators under
supervision of a fully trained person
should use this machine.
before operating sweeper:
•Learn sweeper and prime mover controls in an
off-road location.
•be sure that you are in a safe area, away from
traffic or other hazards.
•check all hardware holding the sweeper to the
host machine, making sure it is tight.
•Replace any damaged or fatigued hardware
with properly rated fasteners.
•Make sure all hydraulic hardware and hydraulic
fittings are tight.
•Replace any damaged or fatigued fittings or
hoses.
•check all tire pressures before sweeping.
•check tire ratings to be sure they match the
prime mover load. weigh the sweeper end of
the prime mover, if necessary, to insure proper
tire rating.
•Remove from the sweeping area all property
that could be damaged by flying debris.
•be sure all persons not operating the sweeper
are clear of the sweeper discharge area.
•Always wear proper apparel such as a long
sleeved shirt buttoned at the cuffs; safety
glasses, goggles or a face shield; ear
protection; and a dust mask.
while operating sweeper:
•when operating sweeper, adhere to all
government rules, local laws and other
professional guidelines for your sweeping
application.