Sweepster 240 series, Руководство оператора

Страница: 30 / 37

30
TROUBLEShOOTING
SLUGGISh
SWEEPER
OPERATION
Insufficient oil flow from Prime Mover.
Hydraulic motor damaged or seals blown.
Prime Mover hydraulic filter is dirty.
Check compatibility between sweeper hy-
draulic flow requirements and Prime Mover.
Increase throttle.
Check for leaks and replace motor if
necessary.
Refer to Prime Mover operator’s manual.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
MOTOR FOR
SWEEPER WILL
NOT OPERATE.
Auxiliary hydraulics control on prime
mover is activated in the wrong position.
Hoses from sweeper to Prime Mover
incorrectly connected.
Obstruction in hydraulic line.
Motor failure.
Refer to Prime Mover operator’s manual.
Refer to Prime Mover operator’s manual.
Check hose routing.
Remove obstruction and replace if
necessary.
Check for leaks and replace motor if
necessary.
MOTOR RUNS BUT
BROOM DOES NOT
TURN
Sheared motor shaft key.
Replace motor key.
OIL LEAKS FROM
MOTOR
BRUSh ROTATES
IN ThE WRONG
DIRECTION
BRUSh SLOWS
OR STOPS WhEN
SWEEPING
Motor seals damaged.
Seals on hydraulic fitting damaged.
Hydraulic fittings loose or damaged.
Hydraulic lines loose or damaged.
Hoses installed incorrectly.
Replace motor shaft seal or motor if
necessary.
Replace hydraulic fitting.
Tighten or replace as required.
Tighten or replace as require.
Switch hoses at the motor end.
Check for material buildup and clean as
required.
Reduce travel speed.
Reduce travel speed or make smaller/
additional passes.
Check for leaks and replace if necessary.
Slider plates are jammed.
Travel speed too fast.
Too much material.
Hydraulic motor failure.