Swann SU3022, Инструкция по эксплуатации

Страница: 6 / 14

OPERATING INSTRUCTIONS
Assembling Your Vacuum Cleaner
Note:
Do not plug the power cord into an
electrical outlet until the vacuum is fully
assembled.
Handle Assembly
1. Carefully unpack all components,
set aside packaging.
2. Lift the vacuum body to
the upright position.
3. Remove the screws (2)
that come attached
to the body.
4. From the rear of the
vacuum, slide the handle
into position (with dust-bin
removed).
5. Once the handle is in
place, secure with
the screws (2). (Fig. 1)
Caution:
Do not over tighten. Over tightening
could strip the screw holes. Do not operate the
vacuum without the handle screws in place.
Cord Assembly
1. Make sure that the quick release cord
holder is in the upright position.
2. Remove
the wire
tie from the power cord.
3. Wrap the cord into
place
by wrapping
it in a clockwise
direction around
the quick release
cord holder and
the lower cord
holder. (Fig. 2)
4. Turn the quick
release cord holder
to the left or to the
right to unwrap the power cord.
(Fig. 2)
Warning:
Do not plug in if the power On/Off
button is in the "On" position
Using the Attachments
1. Place the vacuum in its upright position. Make
sure that the vacuum cleaner is
NOT
plugged
into the electrical outlet when adding or
removing accessories.
2. Turn the carpet adjustment knob to the highest
position (high pile).
3. Remove the hose connector from the rear of the
unit and push in the desired attachment firmly
onto the end of the hose.
4. If additional length is required, attach one or
both of the extension tubes to the hose and then
attach the crevice tool or upholstery brush to the
end of the extension tube.
Warning:
Avoid tipping the vacuum or setting it on
furniture, fringed rugs or carpeted stairs while you
are using the hose with the attachments. When
the vacuum is turned on, the beater brush will
continue to rotate. Avoid leaving the vacuum in
one place for an extended period of time,
particularly on thick carpet.
Caution:
Do
NOT
pull the vacuum cleaner around
the room by the hose as it could tip over and cause
damage. When using the attachments, do
NOT
over extend the hose length when reaching. Trying
to stretch beyond the hose reach could cause the
vacuum to tip over.
How to Start
1. Turn the quick release cord holder to either side
180°to release the power cord.
2. Plug the power cord into the electrical outlet.
3. Depress the handle release pedal to release the
handle.
4. Push the On/Off button to the "On" position to
turn the vacuum on.
5. When using the attachments, the vacuum
must
be in the upright position. (Fig. 3)
Fig. 3
Fig. 2
Fig. 1
5