4
Charging the Transmitter
Quick Start Guide - Remote Control
Charging the transmitter
•
Plug the transmitter charging plug into the
charging port on the transmitter labelled “CHG”
and the USB end into a compatible USB port.
NOTE: The transmitter uses a diff erent charging
cable to the helicopter. When charging, the
red light on the transmitter will glow. When
charging is fi nished, the light will stop glowing.
•
When connected to a mobile device and the
transmitter is turned on from the control
interface, a blue light will glow on the
transmitter. If the blue light begins to fl ash, the
transmitter is low on power and needs charging
with the USB cable.
•
The transmitter will not charge through the
mobile device, even if the mobile device is
plugged into a power source.
Fitting the transmitter to your device
•
Install the transmitter by plugging it into the
headphone socket of your mobile device as
shown in the picture on the right. Make sure it
is properly seated and pushed in all the way or
you may not get a proper connection.
•
When controlling the chopper, ensure the infra-
red LEDs are facing towards the chopper at all
times.
WARNING
: Do NOT fl y near eyes or face.
!
To use the remote control as the controller, you will fi rst need to install batteries.
Replacing Batteries in the Controller
: The battery compartment is located on the
rear of the controller. Undo the screw with a precision screwdriver and open the battery
compartment. Install 6x AA alkaline batteries. Don’t mix old and new batteries. For more
information on battery usage and safety, consult page 13.
IR LEDs
