2
Need help?
Give us a call on
0330 026 6273
and speak to one of our trained advisors.
Important Safety Information
Need help?
Give us a call on
0330 0267 658
and speak to one of our trained advisors.
Please read these instructions thoroughly and retain for future use.
All products supplied by Swan are safe provided they are installed, used correctly and receive regular maintenance in accordance with these
instructions.
If you are in any doubt about your ability to install this product safely you must employ the services of an experienced qualified
plumber.
Remove all packaging and check the components for damage before starting installation. Before starting any installation please consider the
following:
Prior to drilling into walls, check that there are no hidden electrical wires, cables or water supply pipes. This can be checked with the aid of an
electronic detector.
If power tools are used do not forget to:
- Wear eye protection
- Unplug equipment after use
1. Identify all components before fitting.
- 1 x Tap Body
- 2 x Rubber Washers
- 2 x Fixing Nuts
- 1 x Tap Base Washer
- 1 x Hose
- 1 x Handset
- 1 x Bracket
- 1 x Bracket Fixings
2. Fit the tap to the bath using fixing
nuts supplied. The rubber washer
goes between the fixing nut and the
underside of the bath.
3. Connect the hot and cold supplies.
4. Fit the bracket using the fixings
supplied.
5. Connect the hose to the tap body and
handset.
6. Fully open both valves, letting them
run for a few minutes to flush out
the system. Check all joints and
connections for leaks.
Working Pressure Range:
Min 0.2 bar, Max 5.0 bar
Maximum Static Pressure: 10 bar
BS 6700 recommends the temperature of stored water
should never exceed 65°C. A stored water temperature of
60°C is considered sufficient to meet all
requirements and will minimise the build up of limescale
in hard water areas.
Specifications
Installation Steps
This product needs to be installed in accordance with, and meet the
requirements of the Water Supply (Water Fittings) Regulations 1999
and current byelaws. For full Installation Requirements & Notes
(IRN) please visit
www.wras.co.uk/directory.
Isolation valves must be fitted to the inlet water supplies to ensure
ease of future maintenance. Full access must be made available for
future maintenance/servicing purposes. Before installing this
product the water supply must be thoroughly flushed in order
to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
If in doubt, contact a registered plumber or your Local Water
Authority or the Secretary of the Institute of Plumbing,
address as follows:-
The Institute of Plumbing,
64 Station Lane,
Hornchurch,
Essex,
RM12 6NB, Tel: 01708 472791
Installation
Tap Body
Tap Base
Washer
Rubber
Washer
Fixing Nu
t
Hose
Handset
Brac
ke
t
Brac
ke
t
Fixings