Front Panel (Left or Right-Side)
1.
Place the front panel on top of the shower base and
slide it against the back wall panel. Scribe (mark)
the panel, as shown. Cut away the excess material
to allow the front panel to fit precisely against the
back panel. Scribing and cutting the panel will
provide a 90 degree corner with no need for corner
molding. Cutting the side panel to precisely fit the
wall is not necessary if the corner molding supplied
in the kit is used. This corner moulding will cover
gaps up to 1/2”.
2.
Measure the openings for the shower faucet(s) and
shower head.
3.
Transfer the measurements to the front panel.
4.
Cut clearance holes using a router, sabre saw, or
hole saw. Drill from the finished side of the panel.
For best results, when drilling, place a scrap of wood
beneath the hole to ensure a clean cut.
5.
Dry fit the front panel, and make any necessary
adjustments.
BK-FP-003b
BK-FP-003a
BK-FP-002
BK-FP-001
BK-Scribe-02
The Swan Corporation – Swanstone
18
800-325-7008
Installation Procedure
