+ -
Opening the 1060 Housing
Connecting the Heater / Blower Power
3
6
Turn the 1060 housing
back to right side up and
open the top sideways to
allow access to the
camera mounting plate
fitted to the mounting rails
at the bottom of the inside
of the housing. Gently
prise the base plate up
with your hand, or use a
screwdriver if this is too
difficult.
Turn the camera on
and adjust the focus
to suit your
requirement then
close the top of the
1060 housing. Using
a “Philips Head”
screwdriver, re-
tighten the two
screws at the side of
the 1060 housing to
ensure the best
possible weather
seal.
Connect the wires you
passed through the seal
plug to the Heater /
Blower power terminals
with the positive and
negative wires as
marked in this illustration.
Once the wires are in the
screw terminal holes,
tighten the screws down
to give the wires a good
electrical connection.
Turn the 1060 Housing upside-down and then
using a “Philips Head” screwdriver, loosen the
two screws at the side of the 1060 housing until
the top of the casing can be lifted towards the
opposite side of the housing.
+
-
