SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
- 7 -
Forward/ Reverse Rotation Switch
Operation
To
prevent
damage,
do
not
press
Forward/Reverse button until the anvil
comes a complete stop.
Forward Rotation Operation
Push the button for forward rotation. After
use, set the lever to its center position.
Reverse Rotation Operation
Push the button for reverse rotation. Check
the direction of rotation before use. After
use, set the button to its center position.
WARNING! This tool is designed only
to speed the installation and removal
process, and is not intended to replace
a
torque
wrench.
We
strongly
recommend the use of a torque wrench
during the installation process after
using
this
tool,
especially
for
applications where the proper torque is
important.
Battery Pack -
Li-ion Battery Pack
1. For Optimum battery life, store the Li-ion
battery pack following use without
charging it.
2. Do not charge battery when ambient
temperature is below 0
o
C (32
o
F) or above
40
o
C (104
o
F). If the battery pack is used
when the battery temperature is below
0
o
C (32
o
F), the tool may fail to function
properly.
3. This battery pack has the built-in “Battery
Fuel Gauge” Press the gauge button (1)
to check the fuel condition of the battery
pack.
If you notice the battery fuel gauge only
left with one red light that means the
battery is running low.
Charge the battery pack immediately, or the
power of the tool may not reach to your desired
torque.
Battery Pack Life
The rechargeable batteries have a limited life. If
the operation time becomes extremely short
after recharging, replace the battery pack with a
new one.
Battery Recycling
The batteries must be recycled or disposed
properly.
Charging the battery -
for Li-ion/ Ni-MH battery
When charging a cool battery pack (below
0
o
C (32
o
F) in a warm place, leave the battery
pack at the place and wait for more than one
hour to warm up the battery to the level of
the ambient temperature. Otherwise battery
pack may not be fully charged.
Cool down the charger when charging more
than two battery packs consecutively.
Do not insert your fingers/nails into contact
hole, when holding charger or any other
occasions.
1. Place charger in a relatively cool and well-
ventilated area.
2. Plug charger into the AC outlet.
CAUTION: Ensure that the power source to
be utilized conforms to the power requirement
specified on the product nameplate.