SW-Stahl S3202, Инструкция по эксплуатации, Страница: 6 / 12

SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0 www.swstahl.de
Leverkuser Straße 65 Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid E-Mail: info@swstahl.de
- 6 -
- 6 -
ASSEMBLY
Check for damage to the tool, parts or
accessories which may have occurred during
transport. Take the time to thoroughly read
and
understand this manual prior to
operation.
This tool kit contains:
- 1 cordless impact wrench
- 1 or 2 quick charge batteries
- 1 one-hour quick charger
- 1 power cord
- 1 instruction manual
- 1 impact resistant case
Attaching or Removing Battery Pack
1. To connect battery, line up the tracks and
attach the battery pack. Slide toward the
battery pack until it locks into positions with
a click.
2. To remove the battery pack, push on the
RED button on the top and release the
battery pack.
Socket Insertion
Use only 10 mm (3/8”) drive impact sockets with
this tool. Push all the way down the anvil so that is
will not come loose.
WARNING! Use only sockets designed for
impact uses. Other sockets may break due to
the
high stress associated with impact
operations. Always wear eye protection device.
OPERATIONS
This product had been carefully inspected prior to
leaving the factory. It should provide you with years
of satisfying service under normal operating
conditions. Do not, however, force the tool to
perform outside its design parameters. Such usage
will void the warranty.
1.
Slide battery into the bottom of the housing
handle until a click sound occurs. Do not force
battery as it should slide easily into place with
nominal force. Any difficulty doing so would
indicate an incorrect alignment.
2. Select a proper size impact socket and insert into
the quire drive anvil.
3. Pull back power switch slowly to engage the
LED, then pull back further to achieve desired
speed.
4. Depress the trigger switch slightly to start the tool
slowly. The speed increases with the amount of
depression of the trigger for efficient tightening or
loosening of screws.
WARNING! Always wear safety glasses or
face-shields when operating this product.
Failure to do so can result in dust, shavings or
loose particles being thrown into your eyes.