SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
32223L
www.swstahl.de
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
OPERATION INSTRUCTION
Data Hold Mode
In resistance, AC/DC current or AC/DC voltage measurement mode, press the to enter the
Data Hold mode. The present reading is held on the display, “H" appears on the display as an
indicator. To exit the Data Hold mode, just press this button again “H" disappears.
Using Relative Mode
Selecting Relative mode causes the meter to store the present reading as a reference for
subsequent measurements and zero the display.
1. Press the
. The meter enters the relative mode and store the present
reading as a reference for subsequent measurements, the symbol
appears on the
display as an indicator. The display reads zero.
2. When you perform a new measurement, the display shows the difference between the
reference and the new measurement.
3. To exit the Relative mode, press the
again
disappears.
Note:
1. For measurements which have both autorange mode and manual range mode, the
meter changes to manual range mode automatically when you select Relative mode.
Select the desired manual range before you select Relative mode.
2. When you use Relative mode, the actual value of the object under test must not
exceed the full- range reading of the selected range. Use a higher range If necessary.
Manual Ranging and Autoranging
The meter defaults to autorange mode in measurement functions which have both
autorange and manual range mode. When the meter is in autorange mode, “Auto" is
displayed.
Press the "RANGE” button to enter the manual range mode.
The symbol ”Auto" disappears.
Each press of the “RANGE” button increases the range. When the highest range is reached,
the meter wraps to the lowest range.
To exit the manual range mode, press and hold down the "RANGE” button for about 2
seconds. The meter returns to the auto range mode, and "Auto” apears.
Note:
The"
RANGE”
button is enabled only in voltage and resistance measurement functions.
