SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Strasse 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
30133L
If the voltage stays at a low level, the device is not able to proceed with the service work. So stop the
service by holding
N
button for at least 1 second, and an "
Operation failed!
" message comes up.
7. Follow onscreen instructions to complete the first phase of operation:
- Connect filling and bleeding unit.
- Set pressure: 2.0-2.5 bar.
- Wait until the pressure has built up.
- Open bleeder screw at rear left brake caliper.
- Hold bleeder hose tight.
8. If you wish to move to the second phase of operation, press Y button as instructed.
If you do not wish to continue the service, press N button to exit, and an "
Operation failed!
" message
comes up. You can exit the fluid change service at any phase of the operation with N button.
9. To complete the second phase of operation, do the following as instructed:
- Turn off filling and bleeding equipment.
- Wait until the pressure drops.
- Disconnect filling and bleeding equipment.
10. Press Y button to move to next phase.
11. To complete the third phase, do the following as instructed:
- Set pressure: 0.5bar.
- Wait until the pressure has built up.
12
Important:
To complete the brake fluid change process, make
sure vehicle battery is fully charged and is in good condition.
The brake tool keeps detecting battery voltage during the whole
process. Once the voltage is too low to support the operation,
"
STOP: Voltage at control unit SBC xx.xV
"
message indicating battery low comes up.
13
Important:
To complete the brake fluid change process, make
sure vehicle battery is fully charged and is in good condition.
The brake tool keeps detecting battery voltage during the whole
process. Once the voltage is too low to support the operation,
"
STOP: Voltage at control unit SBC xx.xV
"
message indicating battery low comes up.
