10207L
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
SW-Stahl GmbH
Tel. +49 (0) 2191 / 46438-0
An der Hasenjagd 3
Fax +49 (0) 2191 / 46438-40
D-42897
Remscheid
E-Mail:
OPERATING INSTRUCTIONS
•
ALWAYS WEAR
personal protective equipment as protective clothing, mask,
gloves, helmet, shoes etc.
•
Before each use, check the unit for full functional capability. If the functional
capability is not ensured or if damage is detected, the unit should not be used and
you should contact your supplier or manufacturer immediately.
•
When compressing the spring, neither the spring windings nor the jaws should
come in contact with each other, see figure B.
•
The centre line of the spring must always be parallel to the compressing device,
especially for conical springs.
•
Use only suitable jaws for the springs. The spring must rest securely within the
outer rib and the safety ridges. Take care that the spring cannot slide out of the
jaws.
•
Use air wrench only.
•
Pay attention to compressed spring. Never drop or impact compressed spring,
which can cause serious injury.
•
Use only for coil springs mentioned in this user instruction.
•
The bolts of the jaws must always be firmly tightened with 60 Nm torque.
•
For repair, use only original parts and personnel qualified by manufacturer.
Unauthorized parts are forbidden.
•
Do not make any construction changes to the unit, especially to the safety pin.
See figure J for parts list.
•
Keep the workplace clean and tidy at all times.
•
Do not leave compressed spring unattended.
•
Do not use the compressor for other purposes than it was designed for and do
NOT OVER-LOAD
the compressor.
•
For indoor use and room temperature only.
•
Store this product in a dry place.
NOT
in moist places causing corrosion.
•
Keep in mind that compressed spring has a huge energy. The instruction may not
cover all hazards.
ALWAYS BE CAREFUL
when using the coil spring compressor
to prevent yourself from injury.
•
Before and during the clamping process as well as after each operation the
correct position of the spring in the jaws shall be inspected.
FOR YOUR SAFETY
Working safely with this tool is possible only when the operating and
safety information are read completely and the instructions contained
therein are strictly followed. The manual shall be kept in a known
location and be easily accessible for operators and maintenance staff.