7. CONNECTION AND INSTALLATION
Ϝ
After installation of batteries
2
connect the 2.4GHz receiver via the USB cable
6
to an available
USB port of your PC. After connecting to your PC, the device is automatically detected as a game
controller and is fully ready for use. However, for Vibration Feedback function it is necessary to
install drivers. Calibration of the second joystick is also impossible without the installation of drivers.
Ϝ
Shift the POWER ON/OFF switch
1
into the ON position. To connect the gamepad to the receiver
for the
ԛ
rst time, press the FC button on the receiver
7
, its LED
8
will light up, then press the FC
button
'
on the gamepad. There is also another way to connect the gamepad to the receiver: press
the FC button on the receiver, then press the combination of buttons 9+11 simultaneously on the
gamepad and hold these buttons for 15 seconds. Pay attention: the receiver and the gamepad will
be disconnected if the gamer presses one of 9+11 buttons after the connection has been made.
Ϝ
Insert Software CD disk into your PC CD Rom and start setup.exe to install the drivers. To test the
gamepad and make adjustments, choose a Control Panel -> Devices and Printers (Control Panel ->
Devices and Printers), click the right mouse button on the icon of Gamepad and clickl at Parameters.
Properties (Fig. 5) window will open up on your desktop.
Ϝ
Click Function Test (Fig. 5) to test axes and buttons.
Fig. 5
ENG
5
Operation Manual
combaT
