ENG
5
Operation Manual
C2-15
8. INSTALLATION AND OPERATION
C2-15 Multimedia Speaker System can be connected to virtually any audio source: DVD/CD, PC
sound card, etc. (see
fi
g. 4 below).
•
Before connecting make sure that speaker system is switched o
ff
. Then connect built-in acoustic
cables to outputs on the rear panel of subwoofer (see connection diagram above).
•
To connect speaker system to audio source, stereo signal cable mini-jack to mini-jack (stereo
jack Ø 3,5 mm) should be used. Insert one end of the cable into the audio input on the rear panel of
subwoofer, and insert the other end of the cable into audio source input (stereo jack Ø 3,5 mm).
Notes.
Sound is directly dependent on accuracy and reliability of the cable connections.
Recommended to use cables that are supplied complete with speakers.
•
To connect speaker system to CD/DVD-players, stereo signal cable mini-jack (Ø 3,5 mm) to
2*RCA (not included) should be used; its RCA jacks should be connected to outputs of
DVD/CD-players. If such a cable is not available, use adapter mini-jack (Ø 3,5 mm) to 2*RCA
(optional).
•
Insert plug of power cable
j
(see
fi
g. 2) on rear panel of subwoofer into the socket.
•
Shift POWER
On/O
ff
switch into ON position
i
on rear panel of subwoofer.
•
Adjust volume level to its minimum by turning VOLUME control knob
b
on the front panel of
subwoofer counterclockwise as far as it would go.
•
Adjust volume level by turning VOLUME control knob
b
on the front panel of subwoofer or by
pressing buttons VOL+ or VOL-
d
on remote control (see
fi
g. 3).
•
Adjust treble level by turning TREBLE control knob
c
on the front panel of subwoofer or by
pressing buttons TRE+ or TRE-
b
on remote control.
Fig. 4. Connection diagram
C2-15
signal cable
mini-jack
to mini-jack Ø 3.5 mm
DVD/CD/MP3, TV
subwoofer
rear panel
left
speaker
right
speaker
COMPUTER
PLAYER
