Sven Power Pro+ 500, Руководство пользователя

Страница: 13 / 16

6.2. Rear Panel
a
RJ11/RJ45 Jacks: MODEM /LAN Protection
NOTE: This connection is not needed to use the UPS. The UPS works properly with-
out a connection.
b
Com Port RS-232
This is an interface to send signals to and receive signals from the computer.
c
AC Outlet
d
AC Inlet Cord
e
Fuse Holder
7. INSTALLATION
7.1. Connect the loads
First, connect the UPS with Utility, then plug the loads into
the outlets on the rear of the UPS. To use the UPS as a
master On/Off switch, make sure that all of the loads are
switch On.
These UPS outlets provide battery power and surge pro-
tection to the equipment when utility voltage is outside
acceptable limits.
Connect Computer Interface Port.
Connect the supplied interface cable (RS-232) to the
interface port on the rear of the UPS and the computer
interface port.
7.2. UPS Start Up
a. Connect the UPS to the wall receptacle.
b. Push the Main Switch on the front panel to start the
UPS. Line LED (Green) are lit. The start-up procedure
is completed and the loads are supplied by the UPS.
c. To cold start the UPS, press the Main Switch on the front panel. The UPS starts operating and Inverter LED (Red) lights up. The cold
start-up procedure is completed and the loads are supplied by the UPS.
7.3. Turn Off the UPS
Press the Main Switch again.
7.4. Connect Network Surge protection
Connect a 10 base-T/100 base-T network cable into the RJ-11 network surge protection "IN" jack on the rear of the UPS. Connect from
the "OUT" jack with network cabling to network equipment.
7.5. Replacing the Battery
Note: Once the battery is disconnected, the loads are not protected from power outages.
• Disconnect the UPS from the wall receptacle
• Remove the case of UPS
• Gently disconnect plugs of the accumulator
• Replace the battery
• Make assembly in return sequence
• Utilize the old battery according to requirements on preservation of the environment
13
Eng SVEN Power Pro+ 500/700
TEL/FAX
RS232
TEL/FAX
RS232