Elipse 1
– Elipse 2
– Elipse
3
– Elipse
4
– Elipse
5
–
Elipse 6
–
Elipse
7
–
Elipse 8
Connection to an existing masonry
chimney
The stove is approved for a rear connection
to a chimney with a ½ brick connection point
which is approved for a 350°C flue-gas
temperature.
1. Measure where the hole is to be made in
the chimney. Mark the hole and chisel it out
so that it is slightly larger than the diameter
of the chimney insert, allowing sufficient
space to cement the insert in place, using
mortar. Cement the insert into the hole.
2. The stove is usually supplied for a top
connection. If you intend to employ a rear
connection, use the rear connection cover
plate instead to replace the insert on top of
the stove. Apply stove sealant to ensure a
good seal between the stove and the cover
plate. See pictures to the right. .
3. Place the door plate/fireplace base in
position.
4. Fit the connection pipe which is to be fitted
into the chimney insert over the stove
connection insert. Apply a thin layer of stove
sealant around the insert before fitting the
connection pipe.
5. Apply stove sealant to the stove insert and
push the flue pipe into position. The stove is
then placed in.
Elipse 2 in black ,top connected and ready
to be inspected by the chimney sweep.
FittheRuecollarfromthetoptothebackofthestove.
7
Locket tätas med tätningslist som är 8x3mm.
Remove the lid from the back of the stove.
Apply stove sealant to ensure
a
good seal between the
stove and the coverplate.
Place the lid on the top base unit.
Fit the Rue collar from the top to the back of the stove.
