WSE103
3
SVAT ELECTRONICS
Now You Can See
INST
INST
ALLING THE CAMERA
ALLING THE CAMERA
(TRANSMITTER)
(TRANSMITTER)
1.
Unpack the camera.
2.
Decide whether the camera will be wall-mounted or sit on a desk/table top. If wall
mounting, use the mounting hardware. The camera can be adjusted for either
mounting scenario by rotating the camera to the required position.
3.
Decide whether to connect using AC power or 9 volt battery. If using a battery,
connect the 9V battery to the battery adapter, then connect it to the power jack of
the camera. If using the camera power adapter, just connect the power jack. Make
sure the camera is positioned no more than 5 1/2 feet from an AC power outlet.
4.
Select the camera operating channel on the slide switch on side of the housing.
Move the switches to positions 1,2, or 3.
The camera (Transmitter) installation is now complete.
INST
INST
ALLING THE RECEIVER
ALLING THE RECEIVER
MAIN OPERATION
1.
Connect one end of the cable (4 PIN DIN) to the back of the receiver, and the yellow
plug (RCA composite) to the VIDEO IN jack of your TV/VCR/DVR. If you are using
this system with a camera that supports audio, also plug in the red and white
RCA plugs.
2.
Plug the receiver's power supply into the power jack located on the back of the unit
and plug the power adapter into any power outlet.
3.
Place the receiver either on top or near your TV. Rotate the antenna to a
vertical position.
4.
Set your TV to VIDEO INPUT mode to view your camera.
5.
For recording camera footage using your VCR, see advanced features.
