INSTALLATION
TEDDY CAM
1. The Teddy Cam can be powered by either a 9 volt battery or with the
included AC Adapter.
2. Move the Teddy Cam to the desired location.
NOTE:
The transmission range of the Teddy Cam is up to 150ft. Real
distance depends on its operating environment. If you are receiving
interference, try shortening the transmission range. Reposition and/or
adjust the Teddy Cam if video transmission is being degraded by
obstructions in its operating environment.
3. Select the desired transmission channel for the Teddy Cam.
NOTE:
The Teddy Cam has four different transmission channels. Do not
use more than one video camera on the same channel. Doing so will
result in interference and an unclear picture.
•The transmitter is located inside the back of the bear. Unzip the
zipper and pull out the transmitter. Set the switch to the desired
channel (1-4)
5. Place a 9V battery into the battery compartment. Use only alkaline
batteries for the Teddy Cam. The Teddy Cam can also be powered
using the the AC Power Adapter. Plug it into the adapter jack, then
plug the AC Power Adapter into a standard 120V/230VAC electrical
outlet.
NOTE
: Make sure to take the battery out of the battery compartment
before plugging in the AC Power Adapter.
7. Slide the Power ON/OFF Switch to the ON position.
