Suzuki Wagon R RB310, Дополнительное руководство по обслуживанию

Страница: 229 / 254

10B-76 AIR BAG SYSTEM
SDM
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to “DISABLING AIR BAG
SYSTEM” of “SERVICE PRECAUTIONS” in this section.
3) Remove rear console box by removing screws.
4) Release SDM connector locking lever (3) with pushing lock
button (2), and then disconnect SDM connector (1) from
SDM (4).
5) Remove SDM (4) from vehicle.
INSPECTION
• Check SDM (1) for dents, cracks or deformation.
• Check SDM connector (2) for damage, cracks or lock mech-
anism.
• Check SDM terminal for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
WARNING:
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM).
Be sure to read “SERVICE PRECAUTIONS” before start-
ing to work and observe every precaution during work.
Neglecting them may result in personal injury or inactiva-
tion of the air bag system when necessary.
CAUTION:
• Do not connect a tester whatever type it may be.
• Never repair or disassemble SDM (1).
• If SDM has been dropped, or if there are cracks, dents
or other defects in the case or plate, replace it with a
new one.