Suzuki LT-F500F 2002, Руководство по обслуживанию

Страница: 271 / 382

CHASSIS 7-47
• Tighten the steering shaft holder bolts to the specified torque.
#
Steering shaft holder bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Make sure that the wiring harness, cables and brake hose rout-
ing are proper. (
!
9-12 to -20)
TIE ROD
• Install the washer between the tie rod end and steering
knuckle.
• Tighten the tie rod end nuts to the specified torque.
#
Tie rod end nut: 60 N·m (6.0 kgf-m, 43.5 lb-ft)
NOTE:
After installing the tie rod end nuts, install the new cotter pins
into the tie rod end.
• When installing the tie rod, make sure the narrow end
1
of
the tie rod comes out.
$
HANDLEBARS
When installing the lower handlebar holder
1
to the steering
shaft, the higher mating portion must face to forward.
• Set the handlebars to match its punched mark
2
to the mat-
ing face of the handlebar clamps.
• First tighten the bolts
3
to the specified torque and then
tighten the bolts
4
.
#
Handlebar clamp bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the handle switch with the lug
5
on the switch half
inserted into the hole
6
on the handlebars.
NOTE:
After installing the handlebars, make sure that the cable, wiring
harness and brake hose routing are proper.
(
!
9-12 to -20)
The locknuts
2
have left-hand threads.
Forward