Suzuki GSF1200 2001, Руководство по обслуживанию

Страница: 113 / 368

ENGINE 3-75
Driveshaft assembly
• Disassemble the driveshaft assembly as shown in the illustra-
tion.
1
Bearing
5
4th driven gear
2
2nd driven gear
6
Low driven gear
3
5th (top) driven gear
7
Bearing
4
3rd driven gear
REASSEMBLY
Assemble the countershaft and driveshaft assemblies in the re-
verse order of disassembly. Pay attention to the following points:
NOTE:
* Before installing the gears, rotate the bearing by hand to in-
spect for abnormal noises and smooth rotation. Replace the
bearing if there is anything unusual.
* Before installing the gears, lightly coat the driveshaft, counter-
shaft and bushings with molybdenum oil solution.
* Before installing the oil seal, apply SUZUKI SUPER GREASE
“A” to the oil seal lip.
(
99000-25140: SUZUKI MOLY PASTE
)
99000-25010: SUZUKI SUPER GREASE “A”
!
* Never reuse a circlip. After a circlip has been removed
from a shaft, it should be discarded and a new circlip
must be installed.
* When installing a new circlip, do not expand the end
gap larger than required to slip the circlip over the shaft.
* After installing a circlip, make sure that it is completely
seated in its groove and securely fitted.
NOTE:
When reassembling the transmission, attention must be given to
the locations and positions of washers and circlips. The cross
sectional view shows the correct position of the gears, bushings,
washers and circlips.
(
$
3-77)
• When installing a new circlip, pay attention to the direction of
the circlip. Fit the circlip to the side where the thrust is, as shown.
The rounded side should be against the gear surface.
A
Thrust
B
Sharp edge
C
Circlip