Suzuki AVB413D, Инструкция по эксплуатации и сервисная книжка

Страница: 233 / 340

7-10
INSPECTION AND MAINTENANCE
79MH0-74E
(For Diesel Engine Model)
NOTE:
Since special procedures and tools are
required, it is recommended that you trust
this job to your authorised Maruti Suzuki
workshop.
1) Using a socket or a ring spanner
remove oil filter housing cover (3).
61M7001
(1) Loosen
(2) Tighten
2) Remove the old oil filter element and
replace it with a new oil filter element.
3) Clean the surface of oil filter cap and
replace the O-ring.
4) Tighten the oil filter housing cover on
the oil filter housing using a socket or
ring spanner to the specified torque.
Tightening torque for oil filter
Diesel engine:
25 Nm (2.5 kg-m, 18.5 lb-ft)
Refill with Oil and Check for Leaks
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to the “Capacities” item in the
“SPECIFICATIONS” section.
2) Start the engine and look carefully for
leaks at the oil filter and drain plug. Run
the engine at various speeds for at least
5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
oil if necessary. Check for leaks again.
(1)
(2)
(3)
EXAMPLE
NOTICE
To prevent oil leakage, make sure
that the oil filter is tight, but do not
over-tighten it.
NOTICE
• When replacing the oil filter, it is rec-
ommended that you use a Maruti
genuine replacement filter. If you
use an aftermarket filter, make sure
it is of equivalent quality and follow
the manufacturer’s instructions.
• Oil leaks from around the oil filter or
drain plug indicate incorrect instal-
lation or gasket damage. If you find
any leaks or are not sure that the fil-
ter has been properly tightened,
have the vehicle inspected by your
authorised Maruti Suzuki work-
shop.