Suzohapp ARPEGE SECURITY SC-350, Техническое руководство

Страница: 74 / 114

Troubleshooting
Technical Handbook 019722-101 Rev. 05
64
SC-350/360
9.3 Removing a Coin Blocking the Coin Exit
a) Switch Off the machine and disconnect the mains lead from the
supply socket.
b) Open the inspection cover.
c) Raise the feed mechanism (2) and the the thickness guide
block (1).
d) Carefully remove the coin blocking the coin exit.
e) Replace the thickness guide block and the feed mechanism.
f) Close the inspection cover.
Note! The machine will not operate if the inspection cover is open.
9.4 Small Coins not Off-sorted
If small, thin coins are not off-sorted, check the position of the coin
rails (left and right), see “Coin Rail System” on page 75 .
9.5 Good Coins Off-sorted
Check the coin diameter tolerances. Adjust the coin rails (left and
right), see “Coin Rail System” on page 75 .
Check the coin rails. Replace them if worn, see “Coin Guides -
Removal” on page 41 .
1
2
1 Thickness guide block
2 Feed mechanism