ELECTRIC BICYCLE METER KT—LCD5 Product User Manual
- 17 -
Under the metric/imperial units setting interface, if there’s no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set units will be saved.
After finishing the metric/imperial units setting, hold
button shortly
(SW)
to
save the current set values, and then speed and mileage units stop flashing. Hold
button
(SW)
shortly again, and the meter will enter into the maximum riding speed
interface again, or hold
button
(SW)
long for about 2 seconds to exit the general
project setting environment and return to display 1.
○
Exit General Project Setting
Among the three general project settings, after each setting is completed, if hold
button (SW) long for about 2 seconds, all can exit the setting environment and return to
display 1, meanwhile, the current set parameters are saved.
Under each setting interface, if there’s no button operation on the meter for more than
1 minute, and then the meter will automatically return to display 1, and the original set
parameters will be saved.
P Parameter Setting
After finishing metric/imperial unit settings, the speed and mileage units stop flashing.
Within one minute after stopping flashing, hold
button
(UP)
and
button
(DOWN)
simultaneously for about 2 seconds to enter P parameter setting environment.
○
P1 Motor Characteristic Parameter Setting
P1 is motor characteristic parameter setting, P1 = motor gear reduction ratio× number
of rotor magnet pieces, just rounding if there’s any decimal.
After entering P parameter setting environment, the first is to set P1parameter, P1
parameter column flashes. P1 setting ranges between1-255, hold
button (
UP
) or
button (
DOWN
) shortly for selection.
