Suunto Vyper Air, Руководство пользователя

Страница: 47 / 65

6.
Remove the O-ring and the battery retainer.
7. Carefully remove the battery. Do not damage the electrical contacts or the sealing
surface.
8.
Check for any traces of flooding, particularly between the beeper and the lid, or for
any other damage. In case of a leak or any other damage, bring the dive computer
to an authorized SUUNTO dealer or distributor for check and repair.
9. Check the condition of the O-ring; a defective O-ring may indicate sealing or other
problems. Dispose the old O-ring, even if it seems to be in good condition.
10. Check that the battery compartment, battery holder and lid are clean. Clean with soft
cloth if necessary.
11. Gently insert the new battery in the battery compartment. Check the polarity of the
battery: the “-” mark should point toward the bottom of the compartment and the “+”
mark upwards.
12. Reinstall the battery retainer in its correct position.
13. Check that the new lubricated O-ring is in good condition. Put it in the right position
on the battery compartment lid. Be very careful not to get any dirt on the o-ring or its
sealing surfaces.
14. Carefully press the lid onto the battery compartment with your thumb, while making
sure that the O-ring is not at any point protruding out on the edge.
15. Put your other thumb through the locking ring. Press this thumb firmly against the lid
and release the other one. Make sure that the lid is pressed completely down!
16. Turn the locking ring counterclockwise with your free thumb and fingers until it snaps
into its locked position.
17. The dive computer should now active its timekeeping mode and show time 18:00
[6:00 PM] and date SA 01,01. Activate the instrument. Check that
•
all display segments work.
•
the low battery warning is off.
• the buzzer beeps and backlight works.
• all the settings are correct. Reset if necessary.
18. Install the dive computer back into the console or boot and reassemble the strap. The
instrument is now ready for use.
Wrist model:
•
Assembling into the boot: First insert the longer strap in its hole in the front of the
boot and then the dive computer into its cavity in the boot starting at the back end.
Then snap also the long strap end of the instrument into the boot. Stretch the boot
as needed.
•
Assemble the shorter part of the strap. Use the spring bar tool or small screwdriver
to compress the spring bars. Make sure that the spring bars get fully seated so
they will not come off their holes.
Console model
•
Refit the dive computer in the console according the instructions of the console.
CAUTION
Check after the first dives for possible moisture under the transparent
battery compartment lid, indicating a leak.
47