15
E N G L I S H •
User's manual
SANDING SMALL SURFACES USING THE MITRE
GAUGE
Use of the mitre gauge is recommended for
sanding small end surfaces on the sanding disc.
NOTE: Always move the workpiece across the
left side (dust chute end of machine) of the
sanding disc and be sure to hold the workpiece
down tightly onto the table surface.
MAINTENANCE
WARNING: Always disconnect tool from
power source before making any adjustments,
installing or performing maintenance.
CAUTION: Tool service must be performed
only by qualified repair personnel. Service or
maintenance performed by unqualified per-
sonnel could result in a risk of injury. When
servicing a tool, use only identical replacement
parts. Follow instructions in the maintenance
section of this service manual. Use of unau-
thorized parts or failure to follow maintenance
instructions may create a risk of electric shock
or injury.
1. Clean the machine, belt and disc after each
use.
2. Keep the machine dry, clean and free from
oil and grease.
3. Store the tool in a safe and dry place, out of
reach of children.
4. During normal use, sanding belts and disc
can become loaded with sanding debris. Use a
stick belt cleaner (available at most hardware
stores) to remove build-up.
TECHNICAL DATA
VOLTAGE-FREQUENCY
SANDING BELT SIZE
SANDING DISC DIAMETER
SANDING BELT SPEED
WORK TABLE SIZE
POWER
WEIGHT
120 V ~ 60 Hz
4" x 36" (100 x 914 mm)
6" (150 mm)
550 m/min
9" x 6, 2" (226 x 160 mm)
1/2 HP (373 W)
17,62 kg (38,84 lb)
LE612 manual.indd 15
28/09/16 12:34 p.m.
