SURTECO Dollken Profiles HKP 220, Инструкция по эксплуатации

Страница: 9 / 52

9
2 Safety information
2.1 Possible hazards
Burn hazard!
The hook nozzle (1) and melted hot-melt adhesive can reach
temperatures of over 230 °C. Always wear heat protecting gloves if
contact is unavoidable.
Xi
Irritating smells!
Hot-melt adhesives give off vapors which can have irritating smells.
Ensure that there is sufficient ventilation.
If the device is improperly used, isolated instances of mucous
membrane irritation could occur. You should contact a doctor
immediately in such cases!
2.2 Information for safe operation
In order to protect against malfunctions and maloperation, always follow the
following information exactly:
• Remove combustible or heat-sensitive objects from the vicinity of the hook
nozzle (1).
• Only use the device when it is up to temperature.
• The warmed-up device must be placed on its stand (2). It must never be
placed on its side.
• Never operate the trigger (3) with excessive force.
• Protect the device from moisture and wetness (electric shock protection).
• Observe the instructions for Döllken hot-melt adhesive (processing error
avoidance).
• If working above head height, ensure that drops do not form to protect
against burns to personnel or working equipment.
• Always remove the power cable before carrying out any work to the device
(maintenance, cleaning).
• The device may only be operated on sockets with a protective earth.
• Any extension cables must also be provided with a protective earth. Check
that the extension cable is in good condition before use.
• Always remove the mains plug after use. Allow the device to cool down
completely before storing it.
• If you observe damage to the device or the power cable, remove the mains
plug immediately. Ensure that the device is checked immediately by an
electrician. It may only be put into operation once again after repairs have
been correctly carried out (see chapter 5).
Safety information
GB
HKP_220_Doellken_131004.indd 9 22.01.19 13:06