Rear Panel
1. AC POWER CORD
AC power cord for input from 110V to 230V, the power cord itself is auto-switching
.
2. LINK
The line output to next power amplifier to have the same signal input.
3. Signal input
The Signal input is used to adjustment the input sensitivity from various inputs so as to have the best response. There are two
separate gain control for each channel.
4. Fan
Fans for cooling
5. 100V SPEAKER OUTPUT
The speaker outputs shall be connected to 100V line loudspeakers, the negative end to the speaker negative end and the positive
end to the speaker positive end. There are two channel separate 100V speaker outputs which could be managed respectively. These
speaker output are supplied in phoenix connector.
Never mixed the negative end and the positive one, which may cause the short circuit protection.
Never connection the low impedance loudspeaker to these 100V ends, which may burn up the speaker or have heavy distortion.
6. 8Ω SPEAKER OUTPUT
The speaker outputs shall be connected to low impedance 8Ω loudspeakers, the negative end to the speaker negative end and the
positive end to the speaker positive end. There are two channel separate 4Ω speaker outputs which could be managed respectively.
These speaker output are supplied in phoenix connector.
Never mixed the negative end and the positive one, which may cause the short circuit protection.
Never connection the 100V line loudspeaker to these 4Ω ends, which may burn up the speaker or have heavy distortion.
7
/
9
