4
4.Next, set your Height. Then the Age digits are blinking.
4
5.Next, set your Age.
5
6
6.After entering your Age, the scale screen will display “0.0”.
Please immediately step onto
the scale before it turns off and remain your body still.
The scale will save your weight in
your selected profile, and then display your Body Fat, Total Body Water, Muscle Mass,
Bone Mass, and Weight.
This completes the programming of your profile. The next time you use your scale, it will
identify your profile by comparing your current weight with the stored weight.
Note:
If your weight changes by +/-3 kg (+/-6.6 lb) or more, the scale may have trouble
identifying your profile. It is recommended that you re-configure your profile.
USING THE SCALE AS BODY FAT SCALE
1.If you haven’t programmed a user profile, please follow the instructions in “SETUP USER
PROFILE” section to complete the setup.
2.If it is the first time use or has been moved from one place to another, please follow the
instructions in “INITIALIZATION/ CALIBRATION” to initiate the scale.
3.For the most consistent and accuracy results, please measure at the same time of the day,
and do not measure within 30 minutes after a meal or 120 minutes after an exercise.
4.Wipe your feet with a damp cloth, leaving them slightly damp.
5.Press “SET” and select your profile. (This step can be skipped, as the scale can
automatically identify your programmed profile.)
6.Step onto the scale.
7.Stand still and keep fully contact with the 4 stainless steel electrodes until the screen stop
displaying the moving “o”.
USING THE SCALE AS WEIGHT-ONLY SCALE
Your Surpahs
®
Body Fat Scale will operate as a conventional weight-reading scale, there are
no special programming steps are required.
You may simply step on the scale to measure your current weight:
1. Place the scale on a flat hard surface, carpeted or uneven floors may affect accuracy.
2. Step onto the scale platform and remain still while the scale computes your weight.
3. The scale will save your weight.
4. The scale will automatically turn off after a few seconds.
