Page
6
of
7
2.
«ROM»
will
add selected cell to permanent memory
.
A message will appear on the
screen, asking the user for approval.
Choose «
YES»
to confirm writing selected cell to
permanent memory. A permanently stored white-listed cell will be marked with an
asterisk (*) in its first row.
3.
You can delete the permanently stored cell and put it back in the temporarily stored
white-list by choosing a permanently stored cell and pressing "ROM" button again. The
approval message will appear, this time asking whether you agree to remove selected
cell from flash.
.
Note!
Updating your firmware will erase even permanently stored cells!
Turning off and charging.
3.
You can turn ARCAM off by pressing and holding the on/off button located on the right
side. You can release the button as soon as you see the "Power Off" message.
4.
Before charging, always detach the antenna from your ARCAM. The mini-USB charging
port is located at the left side. Whenever you plug in the USB power supply to your
ARCAM, it will automatically turn off and enter the charging mode.
IMPORTANT! Never charge your ARCAM with antenna still
attached to it - this may result in serious Electro Static damage to
pre-amplifier cirquit.
Hard reset.
If you face freezing, or other software issues, you should hard reset the device by
pressing the Reset pin, located on the left side of your ARCAM. Device will reboot and
load a touch panel calibration screen.
Содержание ARCAM
Страница 1: ...ARCAM Spy Camera Detector USER S MANUAL ...
