Surface Concept HVPS-HC, Руководство пользователя

Страница: 10 / 16

10
19“ HVPS-HC Module R012 Manual | Surface Concept GmbH
4.2 General Device Operation
After switching on the 19” Basic Unit, the display shows the “Surface Concept” animated logo, while the
device is scanning for the 19” HVPS-HC Module R012 and its specific settings. This can take up to several
seconds. If the 19” Basic Unit is ready for operation, it switches into the standby mode and shows an empty
mask for the voltage adjustment (see
Figure 3
).
Push the “Start/Standby” button in the lower left
corner of the display to switch on the high
voltage.
Alternatively one can press the “Channel” control
knob.
After switching on the high voltage the device
is in the so called operation mode. In operation
mode the display shows the name of the selected
channel in the top line (in this case “HV 1”) as well
as the output voltage of that channel.
The different HV channels can be selected by
turning the “Channel” control knob.
Figure 3: Standby mode.
Figure 4: Operation mode.
Figure 5: Operation mode – voltage adjustment.
The “Adjust” control knob is used to adjust
the output voltage. Turn the “Adjust” control
knob clockwise/counter-clockwise to increase/
decrease the value of the output voltage in a step
width as defined in the line “edit step”.
The line “set value” displays the nominal value
for the output voltage as adjusted by the user.
Voltage adjustment can only be made in this line.