Telescoping Handle
Clamp
Lever
Forward
Lever
Reverse
Lever
Hand Grip
(Contains extra shear pins)
Fastening
Bolt
Puller Body
Swivel Hook
Figure 1.
4
Product No.
111136
111137
111138
Model No.
JGP-75A
JGP-150A
JGP-300A
Pulling Capacity (lb)
2,860
5,720
11,440
Lifting Capacity (lb)
1,760
3,520
7,040
Force Req. to raise load (lb)
64
93
99
Dimensions (L x W x H)
16-3/4" x 2-1/2" x 9"
21-1/2" x 3-3/4" x 10-1/4"
26" x 4-1/2" x 12-1/2"
Cable Diameter
5/16"
7/16"
5/8"
Net Weight (lb)
39.7
45.2
71.6
UNPACKING
Open carton and check for shipping damage. Report any
damage immediately to your distributor and shipping agent.
Do not discard any shipping material until the Grip Puller is
assembled and operating properly.
Compare the contents of your container with the following
parts list to make sure all parts are intact. Missing parts, if any,
should be reported to your distributor. Read the instruction
manual thoroughly for assembly, maintenance and safety
instructions.
ASSEMBLY AND SETUP
Pre-Lubrication
Before proceeding with assembly, lubricate the puller as
follows: Apply a lubricating oil to the puller mechanisms while
continuously operating the reverse lever. This will help spread
the oil to the internal parts. Use special care to oil pawls and
links well. A wear resistant oil is recommended.
CAUTION: Without proper lubrication, the pawls will fail to
engage the wire rope, and the wire rope will not move.
The above specifications were current at the time this manual was published, but because of our policy of continuous improvement,
JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
*NOTE: The above product numbers do not include the wire rope.
SPECIFICATIONS
INTRODUCTION
This manual is provided by JET covering the safe operation
and maintenance procedures for a JET Grip Puller.
This manual contains instructions on installation, safety
precautions, general operating procedures, maintenance
instructions and parts breakdown. This tool has been
designed and constructed to provide consistent, long-term
operation if used in accordance with instructions set forth in
this manual. If there are any questions or comments, please
contact either your local supplier or SureWerx. JET can also
be reached at our web site: www.surewerx.com
M18-MH111136-38-Eng+Fre-FA.indd 4
2018-07-23 4:11 PM
