SureShot AC-LC2, Руководство по эксплуатации

Страница: 10 / 16

AC-LC2 Liquid Cooler Dispenser
•
SureShot Technical Assistance Center: 888 777-9990 or +1 902 865 9602
6
4. Flush with water.
a. With dispense faucet open and catch container in place under
the faucet, pour 2 pots of hot water (160°F / 70°C) into top tank
and allow to flush through the system and drain out of dispense
faucet. Discard drained water.
Caution: Liquid will be hot!
5. Remove two tanks and screen from the dispenser. See Figure 4.
a. Remove top tank by sliding it out from the dispenser.
b. Remove screen by pulling it up and out from the top tank.
c. Grasp the dispense faucet of bottom tank and pull up over the
two bumps, while sliding straight out, just far enough to grasp
sides of tank for complete removal. Set aside.
Do not use
dispense faucet to carry tank.
d. Remove the top section of the faucet by twisting counter
clockwise 2 full turns and pull out the handle and internals of the
faucet with the silicone gasket.
e. Remove the silicone gasket from the handle by pulling it off the
handle. See Figure 5. Set aside.
6. Wash both tanks, screen, dispense faucet handle and silicone gasket
in hot water with a good quality cleaner at a minimum water
temperature of 140°F
/ 60°C. Wash thoroughly to reach all corners
and crevices.
Note: If a dishwasher is available the items may be cleaned on the
full wash cycle.
7. Install the silicone gasket back on the handle, then assemble the
handle back into the faucet body by twisting clockwise until tight.
8. Rinse well with warm, clean water ensuring water is also flushed
through dispense faucet.
9. Air dry thoroughly.
10. Lubricate O-ring. See Figure 6
a. Locate O-ring and ensure it is on the bulkhead fitting. It is located
on the back wall in the top section of the dispenser. See Figure 7.
b. Apply a small amount of food-grade lubricant to the O-ring on the
bulkhead fitting.
11. Install screen in top tank, then load both tanks completely back into
dispenser.
a. To install screen, set inside the top tank at the front. Ensure
the tab is facing the front and is attached to the front of the top
tank.
b. When loading top tank, ensure it is pushed in all the way
and the hole in the back of the top tank aligns with the
bulkhead fitting inside the back of the dispenser. See
Figure 7.
Note: Lid must close all the way. If lid does not close then
the top tank is not fully installed.
c. To load bottom tank, lift and push back behind the two
bumpers.
12. Flush with product.
The heat exchanger and lines contain water after cleaning.
This needs to be flushed out with product prior to regular use.
a. With dispense faucet open, pour a half pot of product into
top tank and allow to flush through into an appropriately sized catch
container for discarding.
13. Close dispense faucet.
14. Turn
on power switch.
15. To load product, see page 4.
Figure 4
Figure 5
Figure 6
Figure 7