25
2.Installation Steps
2.1
Inducing
a Cavity for Feed Connector
2.2 Inserting the Feed Connector
www.surelight.com
Insert the feed connector pins into the
cavity that you created with the
inducer (backside of PCB)
The following operations are prohibited:
Insert into the front side of the PCB
Insert
crosswise
into the PCB
Insert
crosswise
into the PCB
The silicone gasket is attached on the feed connector.
Rotate the feed connector pin to make its orientation
vertical and insert it into the backside of PCB tightly.
Insert the inducer to the backside of PCB around 10~12mm,
move the inducer up and down 3~5 times gently to create a
small cavity.
Insert the inducer into the backside of PCB
It
will damage the light if insert into front
side of PCB
NEVER insert into the front side
(LED side) of the PCB
PCB
Insertion Placement
PVC Tape
