HUMIDITY SETTINGS (IDEAL = 50% to 65%)
Humidity % is determined by the surface area of the water container/ pan and the amount of fresh air exchange in the hatcher.
You can regulate humidity % by decreasing or increasing the SURFACE AREA of the water and by regulating the fresh air that
comes into the hatcher
The ideal humidity % for incubation is between 50% and 65%
T
O
I
NCREASE
H
UMIDITY
%
1) Fill water container/pan with WARM WATER
2) Adjust the HUMIDITY CONTROL AIR VENT in the front of the hatcher to a LESS OPEN/ MORE CLOSED position
If the above two steps fail to increase humidity, do the following in addition to the above:
3) Place water pans and humidifier in the room where the hatcher is standing to increase room humidity
T
O
D
ECREASE
H
UMIDITY
%
1) Adjust the AIR VENT in front to a MORE OPEN / LESS CLOSED position
2) Remove one of the water containers
If the above two steps fail to decrease humidity, do the following:
3) Remove both water containers completely (Only in very humid / wet areas)
4) Place a dehumidifier in the room (Only in very humid / wet areas)
After you are satisfied with the temperature and humidity you may place the eggs in the hatcher
Hatcher light:
Your hatcher has a light located on the inside of the hatcher. This light may be switched on in
order to view the eggs or chicks inside the hatcher.
VERY IMPORTANT:
Don’t leave the light on as this will negatively effect the functioning of the
hatcher. Only use the light when necessary. Switch the light
OFF
after you have viewed the
eggs/chicks inside the hatcher.
