11
Screw Mounting
Insert a single M4 screw (4mm with head no more than 9mm) into timber, steel or plastic
fencing or posts to hang the Energiser using the screw mounting option (see Point #3).
Steel Post Anti-Theft Mounting
You can mount the Energiser on top of most sizes of steel posts
or “star pickets”
(see Point
#4 & #2). Check your local hardware store for sizes. The Energiser locks to the post using
the supplied key to open the mounting bolt.
Locking Procedure:
1/ Remove the rubber
sealing plug off the key hole and insert the supplied key (see Point #2). 2/ Align the
mounting bolt (see Point #4) with the top hole in the post. 3/ Rotate the key anticlockwise
to retract the mounting bolt. 4/ Push the Energiser onto the post. 5/ Rotate the key
clockwise to lock. 6/ Make sure the mounting bolt is passing through the hole in the steel
post. The Energiser should not pull off. 7/ Remove the key. 8/ Reinsert the rubber seal.
Connecting to Boundary Wire
Prepare both ends of the Boundary Wire:
1/ Remove 12mm of the yellow insulation.
2/ twist the exposed copper wires together.
3/ Fold the twisted copper wires back over
themselves 5mm to double the thickness.
Then push the Green Terminal button to
open the metal jaw, insert the copper wire
then release the button to hold the wire.
Repeat for the Red Terminal.
It doesn’t usually matter which
wire end goes to which
terminal, however, the Activation Distance can vary up to 30% by reversing the polarity.
This can be useful to fine-tune the system to get more distance or less distance.