SureCall Fusion2Go OTR
www.SureCall.com | 1-888-365-6283 | [email protected]
6
Once you have determined the mounting location, assemble the
antenna parts by routing the cable through the mast extension (if
used) and through the cable exit adapter.
If using the provided mounting bracket, we recommend installing
the spring base and mounting bracket before adding the remaining
assembly.
Step 1: Install the Outside Antenna
Install mounting bracket
Secure bracket to vehicle rail as shown using
provided hardware. Secure all four bolts in place
and secure with a wrench.
Secure the assembled antenna to the mounting bracket
Assemble the spring base and mounting bracket by placing the
threads through the opening of the mounting bracket as shown in
the illustration. Use the provided washers on the bottom side of the
bracket opening then add the nut to bottom of the thread to secure
in place.
Once complete, connect the assembled antenna and the spring
base.
Route cable
Once the antenna installation is complete, route the antenna cable
inside the vehicle. To hide the cable, Route cable from outside to the
inside of the cabin under headliner and trim to the desired booster
location on the floor of the vehicle.
If additional cable length is needed, optional 5 ft extension cable has
been provided.
Note: The outside antenna must not be collocated or operating with any other antenna
or booster.
Mounting
bracket
Cable
Mast
extension
(optional)
Cable exit
adapter
Spring
base
Antenna
