SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
11
10
Installing your Hardware
Step 5. Configure Gain Settings
1. Find the PCS and Cellular on the top of the signal booster (See above ).
2. Set the dials according to the coverage area and the distance between the indoor
antenna and boost.
Lighting type
Green light
Yellow light
Yellow light blinking
Indication
ON: Power up.
OFF: No power.
ON: Uplink inactivity in that band.
OFF: Working properly.
Blinking: AGC operating.
OFF: Working properly.
Red light blinking: Shut down
due to over-powering.
OFF: Working properly.
Red light and yellow light
blinking: Self-oscillating.
OFF: Working properly.
Red light blinking
Red light yellow light
alternately blinking
Booster Hardware
The following image shows the key hardware components on the cellullar booster.
Refer to this image as you install your EZBoost 3G kit components.
If you Want to Improve Coverage
• Find a location that receives a stronger signal and relocate the booster to
that location.
• Increase the distance between the booster and inside antenna.
• Be sure your signal booster’s dB gain is turned up to maximum gain on each dial.
Warning: Do not adjust the uplink and downlink dB attenuation settings more than 20dB, this could
cause the booster to shut down.
Troubleshooting
In the event you encounter a problem, follow the suggestions below to resolve the issue.
Table 2-1. Troubleshooting Table
Troubleshooting
Problem
Resolution
Signal booster has no power
After installing your signal
booster system, you have
no signal or reception.
Verify that the booster switch is turned on.
Connect the power supply to an alternate power source. Be sure
the AC outlet is working and is not controlled by a wall switch that
can cut power to the outlet. If the green
POWER LED
on the signal
booster is OFF, return the power supply to SureCall. Contact tech
support at 1-888-365-6283 or [email protected], or go to
www.surecall.com and log on to online support to receive a Return
Merchandise Authorization. (RMA)
Check the strength of the outside signal as close as you can to the
EZBoost
Double-check all signal booster and antenna cable connections.
Be sure your signal booster’s dB gain is turned up to full power on
each dial.
Power Jack
Power Switch
N connector to outside antenna
CELLULAR
dB Gain
dB Gain
PCS
POWER
40
45
50
55
60
65
OFF
47
52
57
62
67
72
OFF
Alert
Alert
